CALAMP WIRELESS NETWORKS INC. BDP4-EXCT769 Manual De Usuario
001-2019-500 Rev 0
Paragon4 – UHF, 700 & 800MHz User Manual
12
4.5
Antenna
4.5.1
Overview
The Paragon4 unit commonly uses three antennas (one transmit and two receive) unless a duplexer is
used with one of the receive antennas; then only two antennas would be needed. If the 10MHz Dis-
ciplined Clock option is sought, there is another GPS antenna in addition to the three already men-
tioned. They should be mounted according to any guidelines supplied with the antennas. For antennas
placement and spacing, consult System Engineering.
used with one of the receive antennas; then only two antennas would be needed. If the 10MHz Dis-
ciplined Clock option is sought, there is another GPS antenna in addition to the three already men-
tioned. They should be mounted according to any guidelines supplied with the antennas. For antennas
placement and spacing, consult System Engineering.
RF exposure warning:
To comply with IC, the antenna(s) must be installed to provide a seperation distance from nearby
persons as determined by the following formula or 20 cm whichever results in the greatest sepa-
ration distance. R > (PxG/6.5)^0.5 cm. P=transmitter power in milli-watts, G=numeric antenna
gain."
persons as determined by the following formula or 20 cm whichever results in the greatest sepa-
ration distance. R > (PxG/6.5)^0.5 cm. P=transmitter power in milli-watts, G=numeric antenna
gain."
4.5.2
Cabling and Connection
1- Route good quality 50-ohm double-shielded coaxial cable(s) (e.g. RG-214 or Heliax) from the se-
lected antenna position(s) to the Paragon4 Radio assembly.
2- Referring to Figure 3 for locating modules, terminate the RX-1 and RX-2 cable-ends at their re-
spective rear position of the receiver module with N-type connectors.
3- Similarly, terminate the TX cable-end at the rear position of the Power Amp’s module with an
N-type connector.
Caution:
When terminating RF cables use brand-name crimping tools (such as AMP, Jensen,
Crimp-Master, etc…) of the correct size for the cable and type of connector used.
Crimp-Master, etc…) of the correct size for the cable and type of connector used.
Common pliers are NOT acceptable.
4.6
Completing the physical Installation
Paragon4 products are factory-configured to user’s requirements and are shipped ready to run.
After new installations:
Re-check that all connections are secure on the radio-modem assemblies (antennas, PC, power
cords etc.)
Check that fuses are inserted.
Turn power supply ON.
You are now ready to check for normal operation (as per paragraph 4.7) and to run the Dataradio web
interface (described in section 6) for testing or trouble-shooting.
interface (described in section 6) for testing or trouble-shooting.
4.7
Checking out Normal Operation
1- Check that power is applied.
2- Check Radio assembly lights for proper operation as per section 5.1
3- Check for proper operation of the BSC2 LEDs.
4- Using the web interface program and an in-line wattmeter, check forward & reverse power to
confirm main antenna installation.
5- Using the web interface, check the RF Data Link with a mobile that can be heard.
If user application and mobiles are available, test the installation by going through a normal sequence
of transmitting and receiving messages.
of transmitting and receiving messages.