Bewator Ltd. 5PQ-SM500 Manual De Usuario

Mount the Reader in a suitable position near the door approximately
1.2m from the floor. The Reader can be installed outside in a
sheltered position.

The Reader has a mounting plate with two oval mounting holes which
are suitable for most installations - you first need to break open the
mounting holes using a screwdriver. There are also four round holes
in the mounting plate which will align with a standard wall box of the
type used, for example, for light switches.

1.

If the Reader is fixed to the mounting plate, undo the four

screws which are in each corner, then place the mounting
plate in position on the wall or door frame and mark the
position of the two mounting holes. Note: the mounting plate
must be positioned with its connector at the top left.

2.

Drill the two mounting holes. The holes accept 3.5mm machine

screws or No 6 wood screws.

3.

The connections are made to the connector on the mounting

plate. Pass the cable through the large hole in the centre of the
mounting plate. Note: the two power supply cables must be
passed twice through the hole in the ferrite bead supplied with
the Reader before they are joined to the connector, as shown in
the following diagram:

-

+

from power supply

each cable passes through ferrite bead twice

0V
V+

to connector on mounting plate

4.

Make the connections shown in the following table as required:

V+

Power supply +V (+ve) unregulated DC

max 36.0V, min 10.0V, 250mA max

0V

Power supply 0V (-ve),

(also ground reference for data output)

Amber

Either: Amber LED control - 0V for amber LED

Or: BCLINK data interface Rx

Horn

Horn - 0V to sound

Red

Either: Red LED control - 0V for red LED

Or: BCLINK data interface address