Bird Technologies Group 61170A Manual De Usuario
TX RX Systems Inc. Manual 7-9469-1.7 02/08/10 Page 11
Message
Context
The device clear errors command was sent
Errors have been cleared successfully.
Submitting the settings
User clicked the “Submit” button on the channel modules page.
The settings have been submitted successfully
The settings have been sent to the control board and saved successfully.
Reloading the admin values
User clicked the “Reload” button on the admin page.
Reloading the system values
User clicked the “Reload” button on the System page.
Reloading the CPS values
User clicked the “Reload” button on the CPS page.
Starting the test signal with X deviation
User clicked the “Start Test Signal” button.
Stopping the test signal
User clicked the “Stop Test Signal” button.
Test signal started with X deviation
The test signal has been started for the active channel module.
Test signal stopped
The test signal was stopped.
Enabling module
The user clicked the “Enable Uplink/Downlink” button.
Disabling module
The user clicked the “Disable Uplink/Downlink” button.
Module enabled
The module has been enabled successfully.
Module disabled
The module has been disabled successfully.
Requesting startup data
Polling channel module settings and data for the selected uplink/downlink.
Requesting device list
Requesting a list of uplinks and downlinks from the control board.
The software failed to find any devices. Please
check your cables.
check your cables.
No uplinks or downlinks have been found.
Obtained device list
A device list has been gathered. initialization will continue.
Disabling all channel modules
The user clicked the “Disable All” button.
Disable all modules command sent
The command to disable all modules has been sent. Results will be dis-
played in a message box.
played in a message box.
Failed to clear errors
An error occurred while clearing errors.
Failed to restore factory settings
An error occurred while restoring factory settings.
Failed to send device ID
An error occurred while identifying a module uplink/downlink.
Failed to start the test signal
An error occurred while starting the test signal.
Failed to stop the test signal
An error occurred while stopping the test signal.
Failed to save settings
An error occurred while saving settings.
Failed to acquire module list
An error occurred while acquiring a list of uplink/downlinks.
Failed to enable module
An error occurred while enabling a module uplink/downlink.
Failed to disable module
An error occurred while disabling a module uplink/downlink.
Failed to load settings
An error occurred while loading settings.
Error loading filter coefficients
An error occurred while loading filter coefficients from a resource file.
Failed to acquire filter settings
An error occurred while reading filter settings from a module uplink/down-
link.
link.
Table 4 (part 2): System status messages.