ADC Telecommunications Inc. PSM230WM Manual De Usuario
Page 10
FlexWave Prism Remote Unit RF Module Installation Guide
©2015 TE Connectivity
TECP-77-141 Issue 8 • 300001744178 Rev H • August 2015
HDM RF Modules
High-Density Module (HDM) RF Modules (
) are designed to provide the ability to deploy either a two
20W Multiple Input Multiple Output (MIMO) paths of the same band, known as a MIMO RF Module; two 20W
Single Input Single Output (SISO) with two different bands, known as dual RF Module; or a single 40W Single
Input Single Output (SISO) RF Module within a single-bay of a PRU. An HDM RF Module does the following:
Single Input Single Output (SISO) with two different bands, known as dual RF Module; or a single 40W Single
Input Single Output (SISO) RF Module within a single-bay of a PRU. An HDM RF Module does the following:
•
interfaces with one Host DART-either Classic or SuperDART, or one CDIU
•
supports two non-contiguous RF slices up to 39 MHz total bandwidth in a Dual or MIMO configuration
•
supports full bandwidth in a SISO configuration, up to 75 MHz
•
supports 20W per band/Path in a Dual/MIMO RF Module
•
supports up to 40W RF output power in a SISO RF Module.
The components of a PRU HDM RF Module are dependent on the module type, as listed in
Table 7.
Components of PRU HDM RF Modules
RF Module Type
DPM
LPA
Duplexer
LNA
Power
Detector
Rx Card
Tx Card
SISO
1
1
1
1
1
1
1
MIMO/Dual Band Module
1
2
2
2
2
2
2
Figure 3. HDM RF Modules