ADC Telecommunications Inc. PSM230WM Manual De Usuario
Page 26
FlexWave Prism Remote Unit RF Module Installation Guide
©2015 TE Connectivity
TECP-77-141 Issue 8 • 300001744178 Rev H • August 2015
Install the RF Module into the Prism Remote Chassis
1
Hold the RF Module so that the DART card(s) face away from the PRU and the Mounting Hook is toward the
Receiving flange on the PRU chassis.
Receiving flange on the PRU chassis.
NOTE:
Always install RF Modules from the bottom up. Do not skip a bay, as this provides more efficient heat
dissipation.
dissipation.
2
Holding the RF Module at a 45° angle in respect to the rear heatsink, rest the bottom surface of the module
on the RF Module shelf, as shown in one of the following graphics, and as applicable to the RF Module.
on the RF Module shelf, as shown in one of the following graphics, and as applicable to the RF Module.
•
Single-Bay RF Module:
•
HDM RF Module:
•
Dual-Bay RF Module:
•
Legacy Dual-Bay 40W RF Module:
Bay C
Bay D
SeRF
Module
Module
Bay A
Bay B
Single-Slot
RF Module
Heat Sink
Figure 11. Installing a Single-Bay RF Module