Biolase Inc. EPIC Manual De Usuario
9 |
P a g e
5 4 0 0 3 2 1 R e v . X : D R A F T
CAUTION:
Use only the Power Module supplied with the EPIC 10 system (Biolase
Part Number 6400142).
Access Key Code
The Access Key Code prevents unauthorized use of the system. It is activated every
time system is turned on with the Power Switch.
The Access Key Code prevents unauthorized use of the system. It is activated every
time system is turned on with the Power Switch.
NOTE:
Turning the laser off by pressing and holding the Control button on the front
panel does not re-set the Access Key Code. Turn the Power Switch OFF only
when the system will not be in use for a long period of time.
CONTROL Button
Once the power switch is set to the ON position the access key code is activated. The
CONTROL button on the control panel must be pressed to enable the footswitch. The
aiming beam will illuminate to indicate that the system is ready for use.
Once the power switch is set to the ON position the access key code is activated. The
CONTROL button on the control panel must be pressed to enable the footswitch. The
aiming beam will illuminate to indicate that the system is ready for use.
Wireless Footswitch
The
EPIC 10
will not emit laser energy until the user presses down on the footswitch in
READY mode. The footswitch is designed to work using wireless technology. Two AAA
batteries are required to power the footswitch (operating voltage – 2 to 3.2 volts).
batteries are required to power the footswitch (operating voltage – 2 to 3.2 volts).
Figure 3: Footswitch
Remote Interlock
This feature allows the device to be connected to the remote sensor which will prevent
its operation when triggered (e.g., by opening door). The electric cable from this
connector should be wired to the normally closed switch, sensing the opening of a door
and turning the laser OFF when switch is open.
This feature is overridden when the plug is not connected.
This feature allows the device to be connected to the remote sensor which will prevent
its operation when triggered (e.g., by opening door). The electric cable from this
connector should be wired to the normally closed switch, sensing the opening of a door
and turning the laser OFF when switch is open.
This feature is overridden when the plug is not connected.
Figure 4: Remote Interlock connector