Badger Meter Inc 2014GW-GXY Manual De Usuario

• 

Precision slotted screwdriver 2 .4 mm (0 .094 inch) blade size

• 

Two 9/16 inch or adjustable wrenches for mounting V-block clamps (standard mounting)

• 

Band-IT®

 

tool (refer to 

) and instructions, a 1/2 inch wrench and a hammer for large diameter  

pole mounting

• 

Wrench for 1-1/16 inch gland nut and 1-1/16 inch dome nut

• 

Strap wrench for backhaul antenna

The V-block mounting equipment is sized to mount the gateway on a vertical or horizontal pole with outer diameters ranging 

from 1-1/4…2-1/2 inches . For mounting on poles larger than 2-1/2 inches, refer to 

 .

1 .  Open the bag of mounting equipment .
2 .  Place two bolts (3/8-16 x 5 inches) through the holes in the top of the gateway mounting backplate (Figure 5) .  

Use the side holes for horizontal installation .

3 .  Place a clamp onto the bolts, as shown below .
4 .  Place a lock washer and nut onto each bolt, as shown below .

The lock washer and nut nearest the enclosure mounting bracket may be omitted when mounting on smaller 

diameter poles to provide additional clamping distance .

 

5 .  Tighten the two nuts with a 9/16-inch or adjustable wrench, so that each lock washer is fully compressed and flat .
6 .  Repeat Steps 2 through 5, attaching a clamp to the bottom of the mounting backplate . Position the gateway on the 

pole and place a clamp on the top bolts .