Badger Meter Inc 2014GWSE Manual De Usuario

The mounting bracket is machined with multiple holes to accommodate different mounting options . Mounting holes and the 

V-Block, banding and wall mounting options are labeled on the bracket . The bracket also has 1/4 inch and 3/8 inch grounding 

points (see Figure 6) which can be used if needed . When shipped, the mounting bracket, TX/RX antenna bracket and backhaul 

antenna bracket are attached . Together they make up the backplate which is attached to the gateway enclosure bracket .  

The circular hole pattern on the mounting bracket can be used to accommodate mounting the gateway on an angled beam 

or pole, if necessary . 
The gateway can also be mounted on a wall . The mounting bracket has four  .28 inch holes marked for this option . 

For a wall mount, customers must supply mounting hardware suitable for the substructure on which the gateway  

is mounted .

For all mounting options, all gateway installation considerations must be observed . Refer to 

"Specifications" on page 6 . 

When shipped, the TX/RX antenna bracket 

is mounted to the top of the mounting 

bracket 

with three locknuts  

(PN: 67624-001) . The mounting holes are 

indicated in Figure 7 . 
Other holes on the bracket can be used 

to accommodate remote installation . 

For more information, refer to 

 in  

the Appendix .

Used to Mount Backhaul 

Antenna Bracket

Used to Mount TX/RX 

Antenna Bracket

Grounding Points