Badger Meter Inc 2014GWSE Manual De Usuario

The V-block mounting hardware is sized to mount the gateway on a vertical or horizontal pole with outer diameters ranging 

from 1-1/4 inches to 2-1/2 inches . For mounting on poles larger than 2-1/2 inches, refer to 

1 .  Open the bag of mounting equipment .
2 .  Place two bolts (3/8-16 x 5 inches) through the holes in the top of the gateway mounting backplate (Figure 10) . Use 

the backplate circular pattern holes for horizontal installation .

3 .  Place a clamp onto the bolts, as shown below .
4 .  Place a lock washer and nut onto each bolt, as shown below .

The lock washer and nut nearest the enclosure mounting bracket can be omitted when mounting on smaller 

diameter poles to provide additional clamping distance .

5 .  Tighten the two nuts with a 9/16-inch or adjustable wrench so that each lock washer is fully compressed and flat .
6 .  Repeat Steps 2 through 5, attaching a clamp to the bottom of the gateway mounting backplate . Position the gateway 

on the pole and place a clamp on the top bolts .

Lock Washers

Nuts

Bolts

Clamps