Badger Meter Inc 2017OCEV5INTL Manual De Usuario
Wall Cover Install Kit (June 2017 & Later)
ORI-UM-02540-EN-01
3 Place the endpoint into the Wall Cover, antenna up
shows the correct placement for the ORION
Cellular INTL endpoint
OTEE:
N
If double-sided tape is included in the kit
contents, you can use the tape to temporarily
secure the endpoint inside the enclosure prior
to mounting the Wall Cover
Figure 7: Endpoint orientation
4 After the endpoint is correctly placed inside the Wall Cover, position the endpoint cable
•
Route the cable through the cutout on the bottom
•
If the endpoint has an in-line connector, place the connector inside the enclosure with the endpoint
and route the connector cable through the cutout on the bottom
•
If you are drilling a hole through the wall behind the enclosure for the endpoint cable, the cable does not need
to route through the cutout at the bottom
OTEE:
N
Gel splice connections, if any, can be placed inside the enclosure
OTEE:
N
See
for additional information
about installing the endpoint outdoors with the Wall Cover
5 Verify that the Wall Cover is properly positioned, with the endpoint antenna up and the endpoint IR LED port down
The IR LED port is shown in
Secure the Wall Cover using customer-supplied screws Installation is complete
Figure 8: 64394-032 installation complete
Page 14
February 2018