Compal Electronics Inc PA3190U-1ETC Manual De Usuario

3

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one of the following measures:

- 

Reorient or relocate the receiving antenna.

- 

Increase the separation between the equipment and receiver.

- 

Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

- 

Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: To assure continued compliance, (example - use only shielded interface

cables when connecting to computer or peripheral devices) any changes or modifications

not expressly approved by the party responsible for compliance could void the user's

authority to operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) This device may not cause harmful interference, and (2) this device must

accept any interference received, including interference that may cause undesired

operation.

This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled

environment.    At least 20 cm separation distance should be maintained from the radiator to

the body of the user excluding hands, wrists and ankles. The radiator is prohibited to be

operated when this device is on the user's pocket or belt-clipped on the body.

This device is specific for pocket PC (PDA) host. It is not allowed to be used in laptop

computer which is possible to have a separation distance shorter than 20 cm.

Since this device is seeking authorization of Limited Module Approval, the host

manufacturer has to mark their host with statement that this host contains a wireless module,

it is recommended to label your host by this statement “ Contains Transmitter Module FCC

ID: GKRPA3190U-1ETC”.