Visonic Inc. MCT423 Manual De Usuario
2
DE3640
Besides its tamper protection role, the tamper switch is
used to reset the transmitter at power up - this is
important for proper function of the unit.
used to reset the transmitter at power up - this is
important for proper function of the unit.
To reset the transmitter and enroll its ID in the control panel’s
memory, proceed as follows:
A. Close the cover and turn the unit over, so that you can see
memory, proceed as follows:
A. Close the cover and turn the unit over, so that you can see
the back of the base.
B. Press the tamper switch once and release it. This will perform
the reset necessary for smooth transmitter power-up.
C. Refer to the control panel’s installation instructions and follow
the procedure given there for enrolling transmitter IDs. When
required to initiate a transmission for enrollment, press the
smoke detector’s test button until the built-in horn sounds.
required to initiate a transmission for enrollment, press the
smoke detector’s test button until the built-in horn sounds.
Note: It is much easier to carry out this operation while holding
the MCT-423 in your hand, close to the control panel.
the MCT-423 in your hand, close to the control panel.
1.5 Mounting the Bracket in Place
Read Section 4 in this manual first, then decide where to install a
detector. Refer to Figures 5 and 6 and proceed as follows:
detector. Refer to Figures 5 and 6 and proceed as follows:
Figure 5. Aligning the Bracket
Figure 6. Mounting the
Bracket
1st.At the chosen location, draw a 15 cm (6”) long horizontal line.
2nd.Press the bracket against the mounting surface, aligning the
2nd.Press the bracket against the mounting surface, aligning the
two longest keyhole slots with the line drawn in Step A. Mark
the drilling spots through two opposite keyhole slots.
the drilling spots through two opposite keyhole slots.
C. Drill two 5 mm (3/16”) holes at the marked spots.
D. Attach the bracket to the wall, using the two screws and
D. Attach the bracket to the wall, using the two screws and
plastic wall anchors (supplied).
1.6 Final Assembly and Test
1st. Before attaching the detector unit to the bracket, it is a good
practice to secure the cover to the base with two screws
(supplied with the unit) through the holes shown in Figure 7.
This will prevent unauthorized opening of the cover.
(supplied with the unit) through the holes shown in Figure 7.
This will prevent unauthorized opening of the cover.