Shenzhen Yitoa Intelligent Control Co. Ltd. 300082 Manual De Usuario
8
www.dimplex.com
Fireplace Installation
Fireplace Assembly
The only assembly required is
to slide the front glass onto the
fireplace and install hardware to
keep it in place.
remove fireplace and glass
1.
carefully from the carton,
discard the plastic bag and
foam packaging.
remove the foam block from
remove the foam block from
2.
within the fireplace (Figure 2).
using side cutters or scissors,
using side cutters or scissors,
3.
cut and remove the two (2)
cable ties as shown in Figure
2 and remove the cardboard
that protects the log set.
Remove the right hand side
Remove the right hand side
4.
trim by removing four (4)
Phillips screws at the side of
the fireplace.
Site Selection and Preparation
spacers.
Do not install the
fireplace insert directly on
carpet or similar surfaces
which may restrict air
circulation. If installing the
fireplace in a carpeted area,
place a one-piece, solid flat
surface under the fireplace.
Ensure that all feet rest
securely on this surface.
Figure 1
27 ⅜”
(695 mm)
22 ⅞”
(580 mm)
23 ½”
(596 mm)
8 ¾”
(222 mm)
26 ¼”
(663 mm)
!
NOTE: The dimensions of the
fireplace with the trim are 27 ⅜
inch (695 mm) wide X 23 ½ inch
(596 mm) high X 8 3/4 inch (222
mm) deep. Dimensions without
trim are 26 ¼ inch (663 mm) wide
X 22 ⅞ inch (580 mm) high X
8 ¾ inch (222 mm) deep. The
fireplace does not require any
additional venting (Figure 1).