Digital Monitoring Products Inc PC0156 Manual De Usuario

Each Status Light indicates the current status of the EM20

Console.

Off............  No AC Power. Check power cord is plugged in.
Blinking ......  AC Power Adapter is plugged in but the battery is 

low. 

On Steady  ..  AC Power and battery good. This is normal.

Off............ Normal
Blinking ...... No telephone line or cellular connection detected.
On Steady  ..  Connected to an operator or sending a message.

Off............ Normal
Blinking ......  Press and release the CANCEL Button to reset activity on console.
On Steady  ..  System troubles such as low battery on pendant or missing pendant.

A locking 4-pin header is provided to connect the Remote Link computer when using a DMP Model 399

Programming Cable to program the unit. After programming is complete, remove the Model 399 Programming

Cable.
Note: To use the programming header with the DMP Model 399 Programming Cable, you must remove the

battery connector. The same 4-pin header is used for programming and for charging the battery.

Using Remote Link Programming Software, Low Power Shutdown can be enabled to preserve the battery

during shipment to the end user by shutting down the processor until AC Power is restored to the unit and 

Voice Prompt Setup is completed.  

The EM20 Wireless Antenna is integrated into the circuit board. The built-in wireless receiver operates

with the DMP 1141 and 1148 transmitters. See section System Components/Accessory Devices for a list of

accessory devices.