Digital Monitoring Products Inc PC0179 Manual De Usuario

The Communication section allows you to configure the communication settings for the

iComSL Communicator. After choosing the Communication Type, continue through the

list of options.

Enter the account num ber sent to the receiver.

The range of account numbers is 1 to 65535. For account numbers of four digits or less,

you do not have to enter leading zeros. The communicator automatically right justifies

the account number.

Enter the number of seconds (15 to 45 seconds) the communicator waits before sending 

burglary alarm reports to the receiver. Enter 0 (zero) to disable this function. The

default is 0.

 The  communicator uses Network communication to DMP Model SCS-1R or SCS-VR

Receivers.

Press COMMAND to display the Test Time. Enter the time of day the communicator sends 

the test report to the SCS-1R or SCS-VR Receivers. Use entries between 12:00 to 11:59

and then choose AM or PM.

Enter how often the panel test report is sent to the receiver. Enter from 1 to 60 days.

Enter zero to disable the test report. Default is 1 (one) day. These options only display if

a test time is entered.

Check-in reports are a method of supervising the panel for communication with the

receiver.
Enter the number of minutes between check-in reports. Select from 0 or 3-240 minutes.

Enter 0 (zero) to disable the check-in option. Default is 0.

Fail Time allows the SCS-1R or SCS-VR receiver to miss a defined number of check-ins

before logging that the panel is missing. For example, if 

NET CHECKIN is 20 and FAIL 

TIME is 30, the SCS-1R receiver only indicates a Panel Not Responding after 30 minutes.

The 

FAIL TIME must be equal to or greater than the NET CHECKIN minutes: If the 

CHECKIN is 20 minutes, the

FAIL TIME must be 20 or more. The maximum FAIL TIME is 

240 minutes. Select from 0 or 3-240 minutes. The default

FAIL TIME is 240 minutes.

Allows you to set the options for the first receiver the communicator attempts to 

contact when sending reports. The communicator supports communication to two 

receivers.

YES enables Alarm, Alarm Restoral, Exit Error, and System Recently Armed reports to be

sent to this receiver. Default is YES

YES enables Supervisory, Trouble, Trouble Restoral, Force Armed, and Fault reports to be

sent to this receiver. Default is YES.

YES enables Opening/Closing, Schedule and Code Changes, and Bypass reports by user to

be sent to this receiver. Default is YES.

Enter YES to enable the Recall Test report to be sent to this receiver.

Enter the first (primary) IP address where the communicator sends messages. The IP 

address must be unique and cannot be duplicated on the network. Enter all 12 digits and

leave out the periods. For example, enter IP address 192.168.0.250 as 192168000250.

The periods display automatically.

Enter the first IP port number to be used in conjunction with the First IP Address. The IP

port identifies the port used to communicate messages to and from the communicator. 

The default IP Port setting is 2001.

COMMUNICATION

ACCOUNT NO:

XMIT DELAY:   

 0

COMM TYPE:     CELL

CELL TST DAYS: 

1

 

CHECKIN:   0

FAIL TIME:    

240

RECEIVER 1 PROG

ALARM NO 

SPV/TRBL NO YES

O/C USER  NO  YES

TEST RPT 

NO  YES

FIRST IP ADDR 

000.000.000.000

FIRST IP PORT

  

TEST TIME

00:00 AM