Digital Monitoring Products Inc PC0179 Manual De Usuario

26

Select Optimize (OPT) to update communication with all Z-Wave devices. Optimize can be used to re-establish

communication after a Z-Wave device has been moved to a different location. When OPTIMIZE is selected, the

iCom makes three attempts to communicate with each Z-Wave device. Z-Wave devices that fail to communicate

during the optimize process are not removed from iCom programming.

1.  Access the User Menu.
2.  Press COMMAND until ZWAVE SETUP? displays.
3.  Press any Select key. The keypad displays ADD LIST REMOVE.
4.  Press COMMAND again to display FAV XFER OPT.
5.  Select OPT, the keypad displays OPTIMIZE while the system is searching for Z-Wave devices.
6.  The keypad will display OPTIMIZE SUCCESS when Z-Wave devices have been retrieved.
7.  Press COMMAND to return to ZWAVE SETUP?.

Note: The keypad will display OPTIMIZE FAILED when communication with a Z-Wave device is not established. Press

COMMAND to return to ZWAVE SETUP? and attempt optimize again. If communication with a Z-Wave device is not

re-established during the optimize process, make sure the device is powered on. If the device that failed has
power, add a repeater between the iCom and the device.