Williams Sound T46 Manual De Usuario
PPA T46 Manual
Page 8
Preliminary
Setting Up the Dual Presets
When the PPA T46 is in Dual Preset mode, it has 2 Basic Features menus – one for
each preset (P1 and P2). When adjusting features, the menu entered is determined by
which preset is selected when the “Menu” button is pressed. A “Preset Indicator” in
the top left corner (see Figure 5) of each Basic Features screen shows which settings
are being adjusted. Features are adjusted the same way they are in Normal Mode.
The Advanced Features apply to both presets.
each preset (P1 and P2). When adjusting features, the menu entered is determined by
which preset is selected when the “Menu” button is pressed. A “Preset Indicator” in
the top left corner (see Figure 5) of each Basic Features screen shows which settings
are being adjusted. Features are adjusted the same way they are in Normal Mode.
The Advanced Features apply to both presets.
Switching Between Dual Presets
From the main screen, use the left and right buttons to toggle between the Dual Presets.
Battery Information
Installation/Removal
Open the battery compartment by lifting the tab on the back of the
transmitter or receiver with your finger. To remove depleted batteries, pull
up on the fabric strip.
IMPORTANT: If alkaline (non-rechargeable) batteries are being
installed, slide the battery selection switch in the battery compartment
to the “Alkaline” position. See Figure 6. If installing NiMH (or
rechargeable) batteries, slide the battery selection switch to the
“NiMH” position.
Press the batteries into place over the fabric strip. Be sure to observe
proper polarity (+/-). Damage due to improper battery installation may
void the warranty on the product.
transmitter or receiver with your finger. To remove depleted batteries, pull
up on the fabric strip.
IMPORTANT: If alkaline (non-rechargeable) batteries are being
installed, slide the battery selection switch in the battery compartment
to the “Alkaline” position. See Figure 6. If installing NiMH (or
rechargeable) batteries, slide the battery selection switch to the
“NiMH” position.
Press the batteries into place over the fabric strip. Be sure to observe
proper polarity (+/-). Damage due to improper battery installation may
void the warranty on the product.
The power LED indicator (see Figure 1) will flash or turn red when the batteries are below 10% capacity. The Battery
Level Indicator (see Figure 3) will show 0 bars, and will blink. Continue to use the equipment until the audio becomes
weak or distorted, or until the equipment quits operating, then replace or recharge batteries. Do not leave dead batteries in
the transmitter or receivers. The power indicator light may remain on, even with a battery that is weak. Typical battery
life for the PPA T46 transmitter is 30 hours with Alkaline AA batteries (BAT 001), or 20 hours with rechargeable NiMH
AA batteries (BAT 026).
Level Indicator (see Figure 3) will show 0 bars, and will blink. Continue to use the equipment until the audio becomes
weak or distorted, or until the equipment quits operating, then replace or recharge batteries. Do not leave dead batteries in
the transmitter or receivers. The power indicator light may remain on, even with a battery that is weak. Typical battery
life for the PPA T46 transmitter is 30 hours with Alkaline AA batteries (BAT 001), or 20 hours with rechargeable NiMH
AA batteries (BAT 026).