BI TAD001 Manual De Usuario
BI TAD
FCC Specifications & Product Installation
Proprietary & Confidential
3
United States FCC, Part 15
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Any changes or modifications made by the user to this equipment that are not expressly
approved by BI Incorporated could void the user’s authority to operate the equipment.
approved by BI Incorporated could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates, uses, and radiates radio frequency energy. If installed incorrectly and/or the
directions are not followed in accordance with the instructions, this equipment may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates, uses, and radiates radio frequency energy. If installed incorrectly and/or the
directions are not followed in accordance with the instructions, this equipment may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Installing TAD
The installation process for the TAD unit involves three separate steps:
Assembling the TAD unit
Sizing for proper fit
Attaching the TAD unit to the client
You will need both a standard and Phillips screwdriver to complete the installation. Discard
the hinge pins after each use. All other supplies are reusable and should not be discarded.
Keep in mind that the battery should be replaced after six months of continuous use.
the hinge pins after each use. All other supplies are reusable and should not be discarded.
Keep in mind that the battery should be replaced after six months of continuous use.
Assembling
Before beginning to assemble the TAD unit, verify that you have the necessary parts:
Parts
4 Standard Screws