Rothenbuhler Engineering Company Inc 1673-2 Manual De Usuario
1673 OPERATION MANUAL REV A
32
Figure 4-3 Activating the Remote Unit
4.1.5.
Press the ON switch. Observe the yellow ON light is on and not flashing. Press the
BATT TEST switch and verify the battery voltage. If the battery voltage is below 7.0 V, the unit
must be recharged before use.
must be recharged before use.
4.1.6.
If the green RX light is on, it suggests there may be an interfering radio signal or noise
present. The RX light is similar to breaking squelch on a handheld radio and does not necessarily
indicate operation is degraded.
indicate operation is degraded.
4.1.7.
Verify the green READY light is on, while the red ARMED light remains off.
4.1.8.
Install the tube into the Shock Tube Firing Tip, and install the tip into the jacks on the
front panel of the Remote as described in section 2.11.
4.1.9.
Install the enable key into the Remote Unit, and observe the yellow KEY light blinks.
4.1.10.
Close the lid on the Remote Unit for environmental protection.
4.1.11.
operation.