Lectrosonics Inc HHAB1 Manual De Usuario

7

Battery Installation

To insert batteries, close the eject lever and insert the 
upper contacts first (closest to the mic capsule). Polar-
ity is marked on the label in the bottom of the battery 
compartment.

To remove the batteries, pull the eject lever outward. 
The battery tips will move outward, making them 
easier to grasp.

The contacts are very tight to prevent the batteries 
from “rattling” as the transmitter is being handled.

IR Sync

The IR SYNC (infrared sync) port is used with receiv-
ers that offer this feature. Settings stored in the receiv-
er for frequency, step size and compatibility mode are 
transferred to the transmitter via the infrared ports. To 
use this feature, open the housing on the transmitter 
to expose the control panel. Hold the transmitter near 
the receiver (less than 3 feet away) so the IR ports 
face each other. The transfer is triggered by a switch 
on the receiver. The LCD on the transmitter will display 
a message confirming that the settings were success-
fully transferred, or an error message that identifies the 
problem that occurred.

Button

Cough

IR Sync

    OK

Control Panel

Six membrane switches on the control panel are used 
to set up the transmitter by navigating the menus on 
the LCD and selecting the desired values.

Setup and Adjustments

Powering On

Press and hold the Power Button for several seconds 
until a countdown on the LCD is completed. The 
countdown from 1 through 3 will appear on the LCD, 
followed by a display of the model, firmware version, 
frequency block and compatibility mode.

Hold

for

Rf On

...3

 

HH
V1.00

Blk  24

Hybrid

When you release the button, the unit will be opera-
tional with the RF output turned on and the Main 
Window displayed.

5

623.400

-40

-20

0

A

NOTE:  If the Power Button is released before the 
countdown is completed, the unit will boot up in 
the “standby” mode with the RF output turned off.