3Com Corporation WL311 Manual De Usuario
Installing the Hardware
9
Installing the Hardware
1 Remove your 3Com Wireless Building-to-Building Bridge from the packaging.
The bridge ships fully assembled. An SMA port for attaching the antenna cable is
located on one side of the bridge (see figure below).
located on one side of the bridge (see figure below).
2 If you plan to mount the bridge on the wall or ceiling, remove the bottom mounting
plate, as shown in the figure below. If you are not mounting the bridge, leave the
mounting plate on the bottom of the bridge.
mounting plate on the bottom of the bridge.
3 To mount the bridge, install the mounting plate where desired using the mounting
hardware provided (see “Physical Dimensions” on page 6 for the physical dimensions
of the mounting plate).
of the mounting plate).
CAUTION: Installing the 3Com Wireless Building-to-Building Bridge, cables, and
antennas should be done only by professional network personnel.
antennas should be done only by professional network personnel.
Wireless
Building-to-Building
Bridge
Po
we
r
Aler
t
Wireless
Ether
net
Ser
ial
5 V
DC
10
Con
fig
.
Seri
al
RJ-4
5
SMA port