3Com Corporation WL311 Manual De Usuario
B
Using the Terminal Configurator
50
■
transmit rate
This parameter controls the data rate at which the radio transmits.
Legal values are: 1, 2, 5, and 11.
■
antenna diversity
This parameter controls antenna diversity. The wireless bridge
has only a single antenna, so this parameter should always be kept at its default value
of no.
of no.
■
enable encryption
This parameter indicates whether WEP encryption by the radio
is desired or not. Setting of the various encryption options is done in the [encryption]
section.
section.
[encryption]
This section contains the configuration parameters that are used when encryption is
enabled. If encryption is not enabled, these parameters have no effect on the wireless
bridge operation.
enabled. If encryption is not enabled, these parameters have no effect on the wireless
bridge operation.
■
transmit key
This value sets which of the following keys are used to encrypt
transmitted data. The default setting for this value is 1.
■
encryption key 1-4
This value is one of the keys to use for encrypting and
decrypting data on the radio. The key should be specified as either a 10-digit or a
26-digit hexadecimal number. Note that the number should always have a 0x before
the hexadecimal digits. Use 10 digits for a 64-bit key, and 26 digits for a 128-bit key.
26-digit hexadecimal number. Note that the number should always have a 0x before
the hexadecimal digits. Use 10 digits for a 64-bit key, and 26 digits for a 128-bit key.
[rmp]
This section contains only a single low-level configuration parameter.
■
ethertype
This value should be changed only if requested by
3Com Technical Support.
[bootp]
This section contains parameters to configure and enable bootp for the wireless bridge.
You can configure the wireless bridge to determine its IP information from a bootp server.
When enabled, the wireless bridge attempts to get its IP Address, Netmask, and Gateway
information from the bootp server.
You can configure the wireless bridge to determine its IP information from a bootp server.
When enabled, the wireless bridge attempts to get its IP Address, Netmask, and Gateway
information from the bootp server.
■
enable bootp
This parameter should be set to Yes to enable bootp. Default value
is No.
■
server ip address
This parameter should be set to force the wireless bridge to get
bootp information from a specific server. Using the default value causes the wireless
bridge to broadcast the requests to all available servers.
bridge to broadcast the requests to all available servers.
■
server name
This parameter has no impact on the operation of the wireless bridge
bootp function, and is simply copied into the bootp messages. If your server requires a
server name in bootp requests, then enter that name here.
server name in bootp requests, then enter that name here.
■
server port
This parameter specifies the port on which the bootp server is listening.
It is unlikely that you should ever have to change this setting.
■
host port
This parameter specifies the port from which the wireless bridge makes
the bootp request. It is unlikely that you should ever have to change this setting.