3Com Corporation WL311 Manual De Usuario
Error Codes
51
[ip]
This section contains values for configuring the IP protocol. IP information is only
necessary to “ping” the wireless bridge, or to “Telnet” to it. You are not required to set IP
address information for normal operation of the wireless bridge, or to configure it using
the Wireless Bridge Manager.
necessary to “ping” the wireless bridge, or to “Telnet” to it. You are not required to set IP
address information for normal operation of the wireless bridge, or to configure it using
the Wireless Bridge Manager.
■
ip address
This value specifies the IP address that will be used by other computers
to communicate with a particular wireless bridge.
■
netmask
When connected logically (AND) to the IP address, this value specifies the
range of IP addresses within the local network.
■
broadcast
In the local network, this value is the IP address used to refer to all
computers simultaneously. The default automatic will work for almost all configurations.
There should be no need to change this value.
There should be no need to change this value.
■
route
For the bridge, this value refer to section names that specify the routing
options. The default of automatic will work for most configurations.
■
gateway
If present, this value specifies the IP address of your Internet router or
firewall. By default, this value is set to none. Change this value to the IP address of
your gateway if you intend to connect to the wireless bridge from a computer outside
your subnet.
your gateway if you intend to connect to the wireless bridge from a computer outside
your subnet.
Error Codes
Error Code
Description
Xxxx: [yyyy]:
section does not exist
Section named yyyy in configuration file named xxxx was missing.
Save your current configuration (if applicable). Reset the wireless bridge configuration to factory
defaults. Reset the wireless bridge. Restore configuration (if applicable).
defaults. Reset the wireless bridge. Restore configuration (if applicable).
Xxxx: [yyyy]: “zzzz”:
entry refers to non-existent
section
section
Entry zzzz refers to a section that is not located in file xxxx.
Save your current configuration (if applicable). Reset the wireless bridge configuration to factory
defaults. Restore configuration (if applicable).
defaults. Restore configuration (if applicable).
Xxxx: [yyyy]: "zzzz":
entry does not exist
Entry zzzz in section yyyy of file xxxx was missing.
Save your current configuration (if applicable). Reset the wireless bridge configuration to factory
defaults. Reset the wireless bridge. Restore configuration (if applicable).
defaults. Reset the wireless bridge. Restore configuration (if applicable).
Xxxx: [yyyy]: "zzzz":
entry is invalid
Entry zzzz in section yyyy of file xxxx contains an invalid value.
Check the entry in the configuration for zzzz. If you cannot find zzzz in the wireless bridge Bridge
Manager program, you may have to use the serial port or Telnet configuration menus.
Manager program, you may have to use the serial port or Telnet configuration menus.
Xxxx: <[yyyy]zzzz>:
Unable to add route.
Route values are out of range compared to the interface values.
Set the route value to automatic. If automatic does not work for your wireless bridge, check the
values you set for the route to make sure they correspond to your other IP parameters.
values you set for the route to make sure they correspond to your other IP parameters.
Xxxx: file does not exist.
Configuration file could not be found.
Reset the configuration to factory defaults, and reset the wireless. If the problem persists, contact
3Com Customer Support.
3Com Customer Support.