Vertical Communications 7500-00 Manual De Usuario
2-6
Assembling the IP Phone
Chapter 2 - Install & Connect the Phone
Xcelerator IP User Guide
March 2007
Connecting the Cables
To avoid any problems caused by power-on, the power source will be applied to the
phone last. Do not plug the adaptor head to the wall socket if you are using Power
adaptor. Do not plug the Ethernet cable to the uplink switch if you are using PoE.
Prepare the Ethernet cable(s), attached in the package, and power adaptor (no need for
Prepare the Ethernet cable(s), attached in the package, and power adaptor (no need for
PoE user). Plug the cable(s) to their corresponding ports on the back of the IP phone. It is
recommended that you set the stand angle at a 60º angle so that room is sufficient for
easy access to connect the cables. Arrange the cables to go under the big U-type frame
as shown in the illustration.
Full Connection Example
The following illustration is an example of a full connection.
(1) To Handset thru curled cord, (2) to IP Network thru Ethernet cable, (3) to PC/
(1) To Handset thru curled cord, (2) to IP Network thru Ethernet cable, (3) to PC/
Notebook thru Ethernet cable, (4) to wall socket thru Power adaptor, and (to use
Headset, plug the headset with R-J9 plug to the Headset jack on the left bottom of the IP
phone) (5) to headset thru headset cable.