Vertical Communications 7500-00 User Manual

2-6

Assembling the IP Phone

To avoid any problems caused by power-on, the power source will be applied to the 

phone last. Do not plug the adaptor head to the wall socket if you are using Power 

adaptor. Do not plug the Ethernet cable to the uplink switch if you are using PoE.
Prepare the Ethernet cable(s), attached in the package, and power adaptor (no need for 

PoE user). Plug the cable(s) to their corresponding ports on the back of the IP phone. It is 

recommended that you set the stand angle at a 60º angle so that room is sufficient for 

easy access to connect the cables. Arrange the cables to go under the big U-type frame 

as shown in the illustration.

The following illustration is an example of a full connection.
(1) To Handset thru curled cord, (2) to IP Network thru Ethernet cable, (3) to PC/

Notebook thru Ethernet cable, (4) to wall socket thru Power adaptor, and (to use 

Headset, plug the headset with R-J9 plug to the Headset jack on the left bottom of the IP 

phone) (5) to headset thru headset cable.