Sennheiser Electronic Corp SCBT8 Manual De Usuario
If a problem occurs ...
MB 110
| 21
If a problem occurs ...
If a problem occurs that is not listed in the above table or if the problem
cannot be solved with the proposed solutions, please contact your local
Sennheiser partner for assistance. To find a Sennheiser partner in your
country, search at www.sennheiser.com.
cannot be solved with the proposed solutions, please contact your local
Sennheiser partner for assistance. To find a Sennheiser partner in your
country, search at www.sennheiser.com.
Restoring factory default settings (Reset)
1
Switch the headset off (see page 16).
2
Keeping both Volume buttons pressed, gently pull the on/off power
slide away from the headset. The LED flashes 3 times purple and then
alternately blue and red. The headset tries to pair with the Bluetooth
devices (see page 11).
slide away from the headset. The LED flashes 3 times purple and then
alternately blue and red. The headset tries to pair with the Bluetooth
devices (see page 11).
Problem
Possible cause
Possible solution
Page
Headset cannot
be switched on
be switched on
The rechargeable
battery is flat.
battery is flat.
Recharge the
rechargeable battery.
rechargeable battery.
No audio signal
The headset is not
paired with the
mobile phone.
paired with the
mobile phone.
Check if the headset is
paired. If necessary, pair
the headset again.
paired. If necessary, pair
the headset again.
The volume is
adjusted too low.
adjusted too low.
Increase the volume.
The headset is
switched off.
switched off.
Switch the headset on.
Headset cannot
be paired
be paired
The pairing does
not work.
not work.
Check if your
Bluetooth device
supports Apple iAP2 or
Android SPP
Bluetooth device
supports Apple iAP2 or
Android SPP
–
The mobile phone
is switched off.
is switched off.
Switch the mobile
phone on.
phone on.
–
Headset does
not react to any
button press
not react to any
button press
The operation of the
headset is faulty.
headset is faulty.
Reset the headset to
the factory default
settings.
the factory default
settings.
1
2
on
press & hold
off