Checkpoint Systems Inc. FISOLRR Manual De Usuario
I L S O p e n P l u s E x i t A n t e n n a I n s t a l l a t i o n : D i s a s s e m b l e t h e G a t e s
1-9
Note: Only perform the next step if disassembling a master gate.
If disassembling a master gate, unscrew the antenna cable from the multiplexer and
signal LED cable from the serial-to-ethernet board.
signal LED cable from the serial-to-ethernet board.
Figure 1.7
Antenna removed from base
8
Separate the base from the upper antenna structure, by sliding the two apart.
9
Separate the very bottom floor mounting plate from the base (electronics bay). The
floor mounting plate will be used as a template for the location of the mounting holes
and wire access holes. Discard any screws used for shipping.
floor mounting plate will be used as a template for the location of the mounting holes
and wire access holes. Discard any screws used for shipping.
Antenna cable
connected to
multiplexer
connected to
multiplexer
Signal LED cable connected to serial-to-ethernet board
Antenna partially
removed from base
removed from base
Nut removed from
screw (not seen) here
screw (not seen) here