Checkpoint Systems Inc. LIBUHX Manual De Usuario
3-3
L i b e r t y U H X U p g r a d e G u i d e
Wiring for front entrance
The network and electrical wiring for all six pedestals originate from the power supply and
network access point installed in the ceiling above side of the entry way on the studded
wall.
The power cabled are shipped in standard 100” lengths with connectors attached to one
The power cabled are shipped in standard 100” lengths with connectors attached to one
end. The other end of the power cable will have connectors added at the site. The power
supply also ships with the connector attached.
The following tasks should be completed by Target IT staff prior to the start of the
The following tasks should be completed by Target IT staff prior to the start of the
installation by Checkpoint Technicians.
1
Target Technician runs CAT 5 cables from the homerun area and terminates at the
power supply with appropriate length.
2
Target Technician installs router and network connection near both shelves.
The following tasks are completed on the installation date by a Checkpoint Technician and
a Checkpoint contractor.
1
Checkpoint contractor runs CAT 5e network cable into a 0.5” PVC conduit to run from
power supply to floor.
2
Checkpoint Technician inserts wiring into 1.00" PVC conduit to run from ceiling to
trench. This PVC conduit is recommended, but is not electrically required. The factory
installed connector should remain at the portion of the PVC pipe nearer the ceiling.
Fish the rest of the cable through the PVC pipe towards the floor.
3
Checkpoint contractor installs walker duct in trench.
4
Checkpoint Technician runs the necessary power cable through the walker duct to the
junction boxes at the foot of each pedestal.
5
Checkpoint Technician crimps the wires into a connector.
6
Checkpoint Technician runs the CAT 5e cables through the walker duct to junction
boxes at the foot of each pedestal.
7
Plug the factory installed connector into the power supply.
The following tasks must be completed by Target IT staff after the trench has been cut and
the CAT 5 cable run in the walker duct by the Checkpoint Technician.
1
Target Technician crimps the wires into an RJ-45 surface mount jack.
•
Pins 1 and 2 - orange pair - white, orange, white
•
Pins 3 and 6 - green pair - white, green, white