Mindray DS USA Inc. WT0707-00000 Manual De Usuario
Panorama™ Operating Instructions
0070-10-0690-01
9 - 63
System Setup Functions
Wireless Tab
9.16.2
Entering Wireless Settings (Telepack-2.4)
This section outlines the settings available in the Wireless tab for the Telepack-2.4. The
settings in the Wireless tab are shown by selecting the Read button and configured by
selecting the Program button.
settings in the Wireless tab are shown by selecting the Read button and configured by
selecting the Program button.
NOTE:
Programming and assigning of the Telepack must be
performed by authorized service personnel only.
performed by authorized service personnel only.
The fields shown in these images are described on the following pages.
FIGURE 9-46 Wireless Tab After Telepack-2.4 Connected
Device ID
The Device ID field displays the identification number that was assigned to the connected
wireless device. A Device ID has a maximum of 8 alphanumeric characters. Data is shown in
the Device ID field when the Wireless tab’s Read sidebar button is selected. If the read was
not successful the Device ID field will remain blank. To view the connection status of the
wireless device check the message in the Connect field. The Device ID field cannot be edited
and has a factory default setting of blank.
wireless device. A Device ID has a maximum of 8 alphanumeric characters. Data is shown in
the Device ID field when the Wireless tab’s Read sidebar button is selected. If the read was
not successful the Device ID field will remain blank. To view the connection status of the
wireless device check the message in the Connect field. The Device ID field cannot be edited
and has a factory default setting of blank.
The Device ID for a monitoring device is set up in the Equipment List tab. For additional
information on setting up a Device ID, refer to the ‘‘Equipment Setup Tab’’ on page 9-33.
information on setting up a Device ID, refer to the ‘‘Equipment Setup Tab’’ on page 9-33.
Telepack IP
The Telepack IP field displays and enables editing of the IP address of the assigned
wireless device. The IP address provides a unique device address of the device on the
Panorama network.
wireless device. The IP address provides a unique device address of the device on the
Panorama network.
NOTE:
Each Telepack-2.4 device must be configured with a unique
IP address from all other devices on the network.
IP address from all other devices on the network.
• Data is shown in the Telepack IP Address field when the Wireless tab’s Read sidebar
button is pressed and the read is successful. The default value of the Telepack IP is
0.0.0.0. If the read is not successful, an error message will be displayed. To view the
connection status for the wireless device, check the message in the Connect field.
0.0.0.0. If the read is not successful, an error message will be displayed. To view the
connection status for the wireless device, check the message in the Connect field.
• A Telepack IP Address can be programmed in a connected device by selecting the
Program sidebar button.
NOTE:
The Telepack IP Address field will not be shown if the device
cannot be recognized or if there is a Read error.
cannot be recognized or if there is a Read error.