E F Johnson Company 2422001-1 Manual De Usuario
ALIGNMENT AND TEST PROCEDURES
7-16
August 2000
Part No. 001-2001-200
Part No. 001-2001-200
7.4.8 REPEATER OPERATION
New HSDB Test
1. On the MPC, switch settings for RS-485 operation
are shown in Figure 7-10.
Figure 7-10 NEW HSDB SWITCH SETTINGS
2. Verify that the repeater is programmed for "Stand
Alone" mode in Setup Parameters-F4 (see Section
4.3.1).
4.3.1).
3. The repeater is now in Normal Operation mode.
Verify by the MPC front panel indicators that no
HSDB alarms have occurred (Alarm Number 10)
see Table 1-2.
HSDB alarms have occurred (Alarm Number 10)
see Table 1-2.
Handshake Test
1. Program an LTR portable or mobile for the follow-
ing parameters.
Home Repeater - Same as repeater number.
Area - Same as repeater’s area bit.
Home Repeater’s Channel Number -
Area - Same as repeater’s area bit.
Home Repeater’s Channel Number -
Sameas repeater’s channel number.
Group 1 Encode/Decode - 1
2. The repeater is now in Normal Operation mode.
3. Key the radio several times on the programmed
System/Group. Access should occur every time.
(Proper Tx/Rx antenna connections are assumed.)
(Proper Tx/Rx antenna connections are assumed.)
Alarm Test
1. The repeater is now in Normal Operation mode.
2. Verify by the MPC front panel indicators that no
alarms have occurred (see Table 1-2).
Figure 7-11 J2 TERMINAL BLOCK
ON
ON
S3
S2
2
1
8
7
6
5
4
3
2
1
4
3
2
1
33
34
J2
TXS+
TXS-
RXS-
RXS+
RXA+
RXA-
TXA+
TXA-