E F Johnson Company 2425770 Manual De Usuario
3-10
Viking Portable 600 Radio Operating Manual
General Operation
full charge/discharge cycles initially. Otherwise the batteries may not provide the number
of operating hours that they are rated for.
of operating hours that they are rated for.
Note
The Li-P battery can only be charged in an approved battery charger. Charging lithium
batteries in nickel only chargers can result in overcharging the batteries and can damage
the cells through swelling.
batteries in nickel only chargers can result in overcharging the batteries and can damage
the cells through swelling.
Do not transmit in close proximity to the charger base (see following).
Do not expose the charger base to high level RF signals while a battery is being charged
because this may cause a charger fuse to blow (especially in the UHF range). Radios
programmed for SmartNet/SmartZone operation, for example, may affiliate while in the
charger which causes them to automatically key. Therefore, do not leave radio power on
while charging as described above.
because this may cause a charger fuse to blow (especially in the UHF range). Radios
programmed for SmartNet/SmartZone operation, for example, may affiliate while in the
charger which causes them to automatically key. Therefore, do not leave radio power on
while charging as described above.
3.4.4 Beltclip Installation
Remove the battery and slide the beltclip into the slot on the battery until it locks into place
(see Figure 3.2). To remove the beltclip, squeeze the tab on the end of the beltclip and
slide the beltclip out.
(see Figure 3.2). To remove the beltclip, squeeze the tab on the end of the beltclip and
slide the beltclip out.
Figure 3.2
Beltclip Installation
3.4.5 Connecting an Accessory
To connect an accessory to the transceiver, proceed as follows:
1 Remove the protective cover over the accessory jack on the side of the transceiver.
2 Insert the hook on the lower end of the accessory connector into the slot on the side of
the transceiver.
CAUTION
!
Beltclip
Locking Tab
Beltclip
Locking Tab
Beltclip
Locking Tab
Beltclip
N
EEDS
TO
BE
R
EPLACED
Preliminary Draft 3/9/12