Honeywell International Inc. WFSSD Manual De Usuario
PRELIMINARY: Notifier Wireless Sensor Network — P/N LS10036-000NF-E:N0 10/10/2013
59
Description
Site Survey
NOTE: You could insert the battery into any available slot. Inserting more than one battery
deters the device from entering the site survey mode.
deters the device from entering the site survey mode.
4. Clear the tamper condition within one minute of the device startup, to enter the site survey
mode. To clear the tamper condition, position the decorative ring around the base of the
detector and rotate it in either direction until the ring snaps to its place (Refer to the below
image). When you clear the tamper, the device starts the transmission that is denoted by LEDs.
Refer to the Table A.1, “Link Test Results-LED Pattern” for results.
NOTE: Due to the absence of the second device that is yet to be introduced, the transmission
fails. Hence, the LEDs in the first device emits solid red.
fails. Hence, the LEDs in the first device emits solid red.
5. Bring the second device to the required location and repeat the steps 3 and 4. The LEDs in the
second device emit yellow light while the test is being conducted.
Results of Link Test
Once you have introduced the two devices, the devices start communicating and the link quality
test is started. The blinking pattern of the LEDs in the device 002 communicates the results of the
link test. To repeat the test, follow the steps 1 to 4.
The following table explains the LED patterns during a link test.
The following table explains the LED patterns during a link test.
Table A.1 Link Test Results-LED Pattern
State
Pattern
LED
Results & Description
LInk Test in
progress
progress
Single blink every 0.5 seconds.
Yellow
Transmission of data
packets to another device.
packets to another device.
Solid
Red
Failure - No Packets
received
received
Single blink every 5 seconds.
Red
Poor -Received only half of
the total transmission of
data packets or poor signal
strength
the total transmission of
data packets or poor signal
strength
2 blinks every 5 seconds.
Red
Marginal - Packets partially
received or marginal signal
strength.
received or marginal signal
strength.
3 blinks every 5 seconds.
Green
Good - All packets received
and good signal strength
and good signal strength
4 blinks every 5 seconds.
Green
Excellent - All packets
received and excellent
signal strength
received and excellent
signal strength