Bosch Security Systems Inc. B115 Manual De Usuario
Telex SAFE-1000
Page 10
7. Monitor the SAFE-1000 Receiver 1
st
operating screen. Note that the
RF (1-100) Bar graph should indicate near the 100 mark. The AF Bar
should show very little If any indication until you talk or sing into
the microphone. Adjust the microphone gain control if necessary to
cause the AF Bar Graph to peak near –6 to –3 but not over +3 for
best performance.
should show very little If any indication until you talk or sing into
the microphone. Adjust the microphone gain control if necessary to
cause the AF Bar Graph to peak near –6 to –3 but not over +3 for
best performance.
8. If you are satisfied with the Group/Channel and audio screen
displays, the mixer or sound system gain/volume can be increased to
monitor the sound.
monitor the sound.
9. If the Group/Channels in step 6. did not agree or you wish to change
them for any reason, proceed with this step . The transmitter
Group/Channel screen should be displayed now. If not, press the
Menu Key one touch at a time until the Group/Channel is displayed.
Press the SET Key one time. The CH number will start flashing. Use
the UP arrow switch to increase the channel number or the Down
arrow to decrease the channel number. Once you have the desired
channel selected, press SET once more. The channel number is now
stored and the Group number will start flashing. Use the arrow
switchs to select the new group number. Press SET again. The
number will continue to flash. Press Menu one time. This will store
both channel and group.
Once the Group/Channel/Frequency is changed, go back to step 7
and 8. and check the set-up.
This completes the quick set-up manual.
Group/Channel screen should be displayed now. If not, press the
Menu Key one touch at a time until the Group/Channel is displayed.
Press the SET Key one time. The CH number will start flashing. Use
the UP arrow switch to increase the channel number or the Down
arrow to decrease the channel number. Once you have the desired
channel selected, press SET once more. The channel number is now
stored and the Group number will start flashing. Use the arrow
switchs to select the new group number. Press SET again. The
number will continue to flash. Press Menu one time. This will store
both channel and group.
Once the Group/Channel/Frequency is changed, go back to step 7
and 8. and check the set-up.
This completes the quick set-up manual.
END