Bosch Security Systems Inc. B115 Manual De Usuario
Telex SAFE-1000
Page 9
10. If the Group/Channels in step 7. did not agree or you wish to change
them for any reason, proceed with this step . The transmitter
Group/Channel screen should be displayed now. If not, press the
Menu Switch one touch at a time until the Group/Channel is
displayed. Press the SET switch one time. The CH number will start
flashing. Use the UP arrow switch to increase the channel number or
the Down arrow to decrease the channel number. Once you have the
desired channel selected, press SET once more. The channel number
is now stored and the Group number will start flashing. Use the
arrow switchs to select the new group number. Press SET again. The
number will continue to flash. Press Menu one time. This will store
both channel and group.
If the Group/Channel/Frequency is changed, go back to step 8. and
check the set-up.
Group/Channel screen should be displayed now. If not, press the
Menu Switch one touch at a time until the Group/Channel is
displayed. Press the SET switch one time. The CH number will start
flashing. Use the UP arrow switch to increase the channel number or
the Down arrow to decrease the channel number. Once you have the
desired channel selected, press SET once more. The channel number
is now stored and the Group number will start flashing. Use the
arrow switchs to select the new group number. Press SET again. The
number will continue to flash. Press Menu one time. This will store
both channel and group.
If the Group/Channel/Frequency is changed, go back to step 8. and
check the set-up.
Quick set-up: BeltPack Transmitter.
1. Insure that the Power switch in Transmitter is in the OFF position.
2. Install a fresh Alkaline Battery into the transmitter.
3. Insure that the Microphone Gain Control is set at about 50 % of
3. Insure that the Microphone Gain Control is set at about 50 % of
rotation.
4. Check the position of the Transmit Power Switch. If this is a single
microphone System, place the switch in the High Power position. If
this is a multiple microphone system, particularly when used with
other non-coordinated units and intermod is experienced, placing the
Transmit Power Switch to “Norm” will frequently eliminate
intermod.
this is a multiple microphone system, particularly when used with
other non-coordinated units and intermod is experienced, placing the
Transmit Power Switch to “Norm” will frequently eliminate
intermod.
5. Place the transmitter Power Switch to the ON position.
6. The Red Low Battery Light near the Power Switch should come on
6. The Red Low Battery Light near the Power Switch should come on
for a few seconds. The display will also come on briefly, displaying
two screens of software versions. The screen will stop at the GP
(Group) and CH (Channel) screen. If the Group and Channel agree
with the receiver Group and Channel, proceed to step 7. If the Group
and Channel do not agree with the receiver, go to step 9.
two screens of software versions. The screen will stop at the GP
(Group) and CH (Channel) screen. If the Group and Channel agree
with the receiver Group and Channel, proceed to step 7. If the Group
and Channel do not agree with the receiver, go to step 9.