Bosch Security Systems Inc. B116 Manual De Usuario
FMR-500/RE-2 System
Page 5
POWER: The Power ON/OFF button is located near the upper left corner
of the display screen. Press the button once to apply power, press
again to remove power. Removing power from any unit saves the
last operation of all screens. Some circuitry will remain active
even though power is “OFF”.
again to remove power. Removing power from any unit saves the
last operation of all screens. Some circuitry will remain active
even though power is “OFF”.
SCREEN: When power is applied, the display screen will show the following:
A. Group (GP), Channel (CH) and Frequency that the unit is set to.
(factory default setting or where last used).
B. Voice or Guitar Mode. Normal default is set to Voice. If in Guitar
Mode, a small guitar symbol will be shown on the display (between
Frequency and RF). If the guitar symbol is absent, the unit is set to
voice mode.
Frequency and RF). If the guitar symbol is absent, the unit is set to
voice mode.
C. Diversity Antenna Symbols. A small antenna symbol will be shown
in between CH and AF. One of two symbols will be on or “flickering”
between symbols, indicating diversity operation. (transmitter or user
must be moving (normally) before diversity action can be seen).
D. Battery Symbol. A small battery symbol will be shown below the
in between CH and AF. One of two symbols will be on or “flickering”
between symbols, indicating diversity operation. (transmitter or user
must be moving (normally) before diversity action can be seen).
D. Battery Symbol. A small battery symbol will be shown below the
Antenna symbol. The symbol will be dark for full battery and light
(proportional) indicating battery strength.
(proportional) indicating battery strength.
E. Clear Scan symbol. When the receiver is in Clear Scan mode, the
symbol will be flashing.
Screen Options:
To change to Guitar operation :
To change to Guitar operation :
Press the Power Off button. Hold the SET button IN then press the
Power On button. The Guitar Symbol should now be shown on the
display. To go back to Voice operation, Press Power OFF, hold the
Set button in and Press Power On.
display. To go back to Voice operation, Press Power OFF, hold the
Set button in and Press Power On.
To select a Special Frequency:
(Other than the pre-programmed Group/Channel/Frequency), press
both the Set and Up buttons at the same time. The Group and Channel
will display dashes (“—“). Press SET and the frequency display will
flash. Press and release the Up button one time to increase the
frequency by 25 KHz. Press and release the Down button one time to
decrease the frequency by 25 KHz. If either the Up or Down button is
held In for approximately 5 seconds, the frequency change will enter
(Other than the pre-programmed Group/Channel/Frequency), press
both the Set and Up buttons at the same time. The Group and Channel
will display dashes (“—“). Press SET and the frequency display will
flash. Press and release the Up button one time to increase the
frequency by 25 KHz. Press and release the Down button one time to
decrease the frequency by 25 KHz. If either the Up or Down button is
held In for approximately 5 seconds, the frequency change will enter