Motorola Solutions Inc. 99FT4100 Manual De Usuario
Label
Description
3
Transmitter RF (Tx) Input
4
Receiver RF (Rx) Input
5
Front Panel Flex Connector
4 Install the antenna switch into the repeater, as follows:
a Place the antenna switch into the chassis and align the screw openings, as shown in
Figure
30: SLR 1000 Repeater Front View (without top cover) with an Antenna Switch on page 76
.
b Secure the antenna switch to the chassis with the two M3 screws using a T10 bit. Torque to
10 in./lbs.
c Connect one end of the power cable into the P1000 connector on the antenna switch and the
other end to the header connector on the repeater board.
d Connect one end of an MCX cable into the J1000 connector on the antenna switch and the
other end to the Tx output port.
e Connect one end of the other MCX cable into the J1001 connector on the antenna switch
and the other end to the Rx output port.
f Connect the Rx cable to the J1002 connector on the antenna switch.
g Reattach the front panel flex cable to the front panel display board, making sure not to bend
the cable.
The cable stops at the black line.
h Place the top cover back onto the chassis, making sure not to pinch any cables.
i
Hold the cover onto the chassis and carefully turn the repeater over.
j
Reinstall the four M4 screws using a T10 bit. Torque to 20 in./lbs.
5 Restore power to the repeater.
Figure 30: SLR 1000 Repeater Front View (without top cover) with an Antenna Switch
Table 25: SLR 1000 Repeater Front View (without top Cover) with an Antenna Switch Callout Legend
Label
Description
1
Transmitter RF (Tx) Output
2
J1000 Connector
3
P1000 Connector
4
J1002 Connector
5
J1001 Connector
6
Receiver RF (Rx) Output
7
Transmitter RF (Tx) Input
8
Header Connector
9
Receiver RF (Rx) Input
10
Front Panel Flex Connector
MN003557A01-AA
Chapter 9: SLR 1000 Maintenance and Disassembly/Reassembly
Chapter 9: SLR 1000 Maintenance and Disassembly/Reassembly
76
Send Feedback
Preliminary
FCC
Filing