Motorola Solutions Inc. 99FT4100 Manual De Usuario

Proper installation ensures the best possible performance and reliability of the repeater. 
Pre-installation planning is required. This includes considering the mounting location of the equipment
in relation to input power, antennas, and system interfaces. Also to be considered are site environment
conditions, the particular mounting method (several available), and required tools and equipment.

It is highly recommended to read the following before installing this type of equipment for the first time:

• this entire installation section before beginning the actual installation, and

• the Motorola Solutions Quality Standard Fixed Network Equipment Installation manual, R56 (which

can be obtained by ordering CDROM 9880384V83), specifically refer to the information on ground
connection for lightning protection.

The following information is an overview for installing the repeater and ancillary equipment. 
Step-by-step procedures for each of the major installation tasks are then provided beginning in 

Mechanical Installation on page 82

.

• Plan the installation, paying particular attention to environmental conditions at the site, ventilation

requirements, and grounding and lightning protection.

• Unpack and inspect the equipment.

• Mechanically install the equipment at the site.

• Make necessary electrical and cabling connections, including the following:

- DC input cabling

- Coaxial cables to transmit and receive antennas

- System cables

• Perform a post-installation function checkout test of the equipment to verify proper installation.

Proceed to the Optimization procedures to customize the repeater parameters per customer
specifications (such as operating frequency, PL, codes, and so on.)

The installation location of the SLR 1000 Repeater must follow precautions and be conducted in such a
way so that access is limited to technicians with adequate training and skills.

CAUTION: The repeater is a natural-convection cooled device and may get hot when installed
in hot and/or high solar load environments. Use of on-board antennas also creates a potential
exposure to RF energy that must be considered.

The repeater may be installed in a suitable, restricted access, indoor or outdoor location suitable for
electronic communications equipment that do not exceed the equipment specifications for temperature
or ingress. Unit orientation, solar loading, antenna, and cable load quality may all affect the
temperature and performance of the unit.

MN003557A01-AA

SLR 1000 Installation

Send Feedback

  77