Motorola Solutions Inc. 99FT4100 Manual De Usuario

SLR 1000 Repeater

1

Serrated Hex Flange M3 Screws

4

Perform this procedure to mount the SLR 1000 Repeater to either a wall or to a ceiling.

NOTICE: A wall mount provides a vertical fin orientation. This orientation is required for high
temperatures and maximum performance.

Prerequisites: Obtain the following:

• Contents of the repeater package. See 

SLR 1000 Repeater Package Contents on page 82

.

• Four #10/32 lag bolts (not included in the repeater package).

• Torque wrench, adjustable wrench, or a ratchet with a 10mm socket

1 Attached the bracket to either the wall or ceiling using four #10/32 lag bolts. See 

Figure 31:

Bracket Mounting Holes on page 83

.

2 Insert the four M6 screws into the repeater chassis side fins and partially tighten. See 

Figure 32:

Location of Repeater M6 Screw Mounts on page 83

.

3 Place the repeater chassis into the bracket by sliding the M6 screws into the receiving slots on

the bracket. Torque to 60 in-lb. See 

Figure 33: Bracket Receiving Slots on page 83

.

Perform this procedure to mount the SLR 1000 Repeater to a pole.

Prerequisites: Obtain the following:

• Pole Mount Kit. Consists of:

- One pole mount bracket

- One ½ in. U-bolt

- Two ½ in. bolts

- Four ½ in. nuts

• Torque wrench, adjustable wrench, or a ratchet with a 10mm socket

When and where to use:
There are two possible options for the pole mount installation:

1 Using a U-bolt with four ½ in. nuts for poles with a diameter between 2 – 3.5 in.

MN003557A01-AA

Chapter 10:  SLR 1000 Installation

Send Feedback

  83