Motorola Solutions Inc. 99FT4100 Manual De Usuario
Appendix D: SLR 1000 Series Third
Party Controllers
Overview
The SLR 1000 Repeater is capable of interfacing to a number of third party controllers through the
four-wire and GPIO/ GPI interface afforded by the back panel AUX connector. This section covers the
connections and signal levels between the third party controllers and the repeater, as well as the audio
path configuration needed through Radio Management (RM). Note that this section is not a substitute
for a more comprehensive instruction detailed in the vendor’s manuals of their respective third party
controllers.
four-wire and GPIO/ GPI interface afforded by the back panel AUX connector. This section covers the
connections and signal levels between the third party controllers and the repeater, as well as the audio
path configuration needed through Radio Management (RM). Note that this section is not a substitute
for a more comprehensive instruction detailed in the vendor’s manuals of their respective third party
controllers.
The third party controllers supported by the repeater are as follows:
• Tone Remote Adapter (Motorola Model L3276)
• External Supply
• 2-Channel Steering Maximum
CAUTION: Do not hot swap any of the third party controllers as this could (at a minimum)
cause a malfunction with the repeater.
cause a malfunction with the repeater.
NOTICE: The repeater only support the third party controllers noted above when it is configured
in analog mode. The screen capture below shows the RM location to configure the repeater for
analog mode.
If the third party controllers are supplied power by the repeater, then the repeater needs to be in
a powered off state when establishing (or removing) the connection to the repeater back panel
connector.
in analog mode. The screen capture below shows the RM location to configure the repeater for
analog mode.
If the third party controllers are supplied power by the repeater, then the repeater needs to be in
a powered off state when establishing (or removing) the connection to the repeater back panel
connector.
Figure 38: Radio Management Settings to Configure SLR 1000 Repeater for Analog Mode
Tone Remote Adapter
When a dispatch console or deskset sends out signals to a remote repeater, it does so over a Wireline.
Two types of signals are sent:
Two types of signals are sent:
• Audio signal
• Command signals (function tones) that are used to perform the remote control functions.
The SLR 1000 Repeater is capable of decoding function tones, sent over a Wireline from a remote
analog deskset or console, through the Motorola Solutions Tone Remote Adapter (Model L3276).
When properly configured, the Tone Remote Adapter performs the following functions in conjunction
with the repeater:
analog deskset or console, through the Motorola Solutions Tone Remote Adapter (Model L3276).
When properly configured, the Tone Remote Adapter performs the following functions in conjunction
with the repeater:
• Transmit and Receive Audio
• PTT
• Monitor
• Channel Select (up to four frequencies)
• Wildcard (such as, Repeater Knockdown)
See Motorola Solutions Tone Remote Adapter Manual (supplied with the Tone Remote Adapter) for
specifications, operation, installation, alignment, programming, alternate configurations, and repair
information.
specifications, operation, installation, alignment, programming, alternate configurations, and repair
information.
MN003557A01-AA
Appendix D: SLR 1000 Series Third Party Controllers
Send Feedback
95
Preliminary
FCC
Filing