Panasonic Corporation of North America 11GR1202 Manual De Usuario
11
RQT9655
Others
To check the Wi-Fi
®
signal strength where the unit
is located.
Preparation
Connect this unit to the wireless network. (> 5)
Preparation
Connect this unit to the wireless network. (> 5)
1
Stop the AirPlay playback to this unit.
≥ Wait for at least 15 seconds before
proceeding to step 2.
2
Press and hold [VOL +] and then also
[VOL –] on the main unit for more than 2
seconds.
[VOL –] on the main unit for more than 2
seconds.
≥ The operation indicator (> 4) blinks a set
number of times.
≥ A stable connection is available when the operation
indicator blinks 3 times.
Change the position or angle of your wireless network
router or the unit in the following cases:
– The operation indicator only blinks 2 times or 1 time.
– The sound is interrupted.
Change the position or angle of your wireless network
router or the unit in the following cases:
– The operation indicator only blinks 2 times or 1 time.
– The sound is interrupted.
Occasionally, Panasonic may release updated
software for this unit that may add or improve the
way a feature operates. These updates are
available free of charge.
Preparation
Connect this unit to the wireless network. (> 5)
software for this unit that may add or improve the
way a feature operates. These updates are
available free of charge.
Preparation
Connect this unit to the wireless network. (> 5)
≥ Make sure that the wireless network is connected to the
Internet.
1
Press and hold [VOL –] and then also
[– WPS] on the main unit for more than 2
seconds.
[– WPS] on the main unit for more than 2
seconds.
{.
After the update has finished, the operation
indicator (> 4) lights.
indicator (> 4) lights.
2
Disconnect the AC adaptor and reconnect
it after 3 minutes.
it after 3 minutes.
≥ Downloading will require several minutes. It may
take longer or may not work properly depending on
the connection environment.
the connection environment.
≥ If the update is unsuccessful, the operation indicator will
blink and light in a specific sequence.
Wi-Fi
®
signal strength
Software update
DO NOT DISCONNECT the AC adaptor while
this unit is updating.
this unit is updating.
≥ During the update process, no other operations can be
performed.
≥ If the update is unsuccessful, the operation indicator
will blink and light in a specific sequence. (> below)
No. of blinks
Problem and solution
3
The software download has failed.
Please try again later.
Please try again later.
The server cannot be found. Make
sure that the wireless network is
connected to the Internet.
sure that the wireless network is
connected to the Internet.
2
This unit cannot connect to the
network. Check the network
connection.
network. Check the network
connection.
1
The update has failed. Turn this unit
off and remove the AC adaptor.
Reconnect the AC adaptor and try
again.
off and remove the AC adaptor.
Reconnect the AC adaptor and try
again.
SC-AP01PPC~RQT9655.book 11 ページ ２０１２年２月２日 木曜日 午後１０時４２分