General Research of Electronics Inc 0712902 Manual De Usuario

PSR-200U Owner’s Manual Draft 

 

3. Press ^ on the host scanner. 

 

4. SEndInG appears at the host scanner. 

 

To exit clone mode after the data transfer is complete, remove the cable. 

 

No ConnEct appears if you try to connect to another model scanner. The PSR-200U does 

not clone with other scanner models. 

 

 

INITIALIZING THE SCANNER 

 

If the scanner’s display locks up or does not work properly after you connect a power source, 

you might need to initialize the scanner. 

 

Important: This procedure clears all information you stored in the scanner’s memory. 

Initialize the scanner only when you are sure the scanner is not working properly. 

 

1. Turn off the scanner, then turn it on again. WELCOME SCAnnInG rECEIVEr appears. 

 

2. Press 0 while welcome message appears. Then press 1. InItIAL appears about 2 seconds. 

After 2 seconds, YES ---Ent and No ---CLEAr appears alternately. 

 

3. Press ENT. WAIt appears for about 2 seconds. 

 

Note: Do not turn off the scanner until the initialization is complete. When the initialization is 

complete, 1CH 000.0000 appears on the display. 

 

Birdie Frequencies 

 

Every scanner has birdie frequencies. Birdies are signals created inside the scanner’s 

receiver. These operating frequencies might interfere with transmissions on the same 

frequencies. If you program one of these frequencies, you hear only noise on that frequency. 

If the interference is not severe, you might be able to turn SQUELCH clockwise to cut out 

the birdie. 

 Page 

32