ICOM 318200 Manual De Usuario

89

SET MODE

10

Select whether or not to output the audio from the 
[USB] connector on the rear panel, according to the 
squelch state.
The same audio signals are sent from the [USB] con-
nector and the [ACC] sockets.
-  The beep tones and the voice synthesizer announce-

ments are not sent.

-  The received audio output level cannot be adjusted 

with the [AF] control.

s

regardless of the squelch state.

s

squelch is open.

Set the input modulation level of the [USB] connector 
TO

Select the desired connector(s) for data modulation

 

input in the data OFF mode.

s

s

s

(pin 11).

s

Select the desired connector(s) for data modulation 
input in the data mode.

s

s

s

(pin 11).

s

Set the CI-V data transfer rate between 300, 1200, 
4800, 9600, 19200 bps and “Auto.”
When “Auto” is selected, the baud rate is automatically 
set according to the data rate of the connected con-
troller.

To distinguish equipment, each CI-V transceiver has 
its own Icom standard address in hexadecimal code.

The IC-7410’s address is 80h.

When 2 or more IC-7410’s are connected to an op-
tional CT-17 

CI

-

V

 level converter, rotate [DIAL] to se-

lect a different address for each IC-7410; the range is 
01h to DFh.

Turn the transceive operation using the CI-V system 
ON or OFF.
When this item is set to ON, changing the frequency, 
operating mode, etc. on the IC-7410 automatically 
changes those settings on other Icom HF transceivers 
or receivers, and vice versa.

s

Select the function for the USB port on the rear panel.
s

.

s

coded signal.

Set the RTTY decode monitor speed to 300, 1200, 
4800, 9600 or 19200 bps.

Use as a simple frequency check of the transceiver. 
See page 98 for calibration procedure.

./4% Turn OFF the calibration marker after check-
ing the frequency of the transceiver.

s

During frequency calibration, set the internal refer-
ENCE

./4% The default setting is different for each 

transceiver.

N Set mode description (Continued)