ICOM AP-3 Manual De Usuario

PANEL DESCRIPTION

2

6

■

■

■

LAN

LAN

POWER

DC

WIRELESS LAN CARD

ETHERNET

HUB PC

RESET

INIT

MODE

This lamp illuminates when the power to the AP-3 unit is
on.
This lamp flashes slowly when the unit is in [Initialize
mode] (

☞

p. 63) and rapidly when the unit is in [Update

Mode] (

☞

p.68). 

q

This lamp illuminates when the wired LAN (Ethernet) con-
nection is normal.
This lamp flashes when the AP-3 unit is communicating
with a wired LAN or wireless LAN.
This lamp goes out if the [ETHERNET] port on the rear
panel can not recognize the LAN connection. In this case,
check the connection of the Ethernet cable and the set-
ting of the [HUB/PC] switch. (

☞

p. 8, 14, 15)

w

This lamp illuminates when the wireless connection to the
AP-3 unit is normal.
This lamp goes out if a wireless communication abnor-
mality occurs. The lamp will also go out if all wireless ter-
minals are inactive for more than one or two minutes or
move out of the wireless communication area for more
than one or two minutes. 
If this lamp does not illuminate, check such items as the
IP address of the wireless terminal, the [Network Mode]
and [ESS ID] (

☞

p. 38) of the wireless LAN card installed

in the wireless terminal, and the [MAC Address Security]
settings (if used). 
* This lamp cannot be used to determine whether or not

the LAN card is installed into the PCMCIA slot. 

e