Canberra Industries RMSA7070822 Manual De Usuario
• In the Save As window, browse to the User file location and save the Seal specific
.hex file with a unique name. For example, if the new .hex file has embedded ID 6F,
save the .hex file as FullUser_ID6F.hex.
save the .hex file as FullUser_ID6F.hex.
• If the Seal is to be programmed with the PICKit2 dongle, exit the MPLAB IDE
application and use the
Writing the Hex File to the Seal with PICKit2 section
.
Otherwise, remain in the MPLAB IDE and use the
Writing the Hex File to the Seal
with ICD3 section.
2.1.4 Writing the Hex File to the Seal with ICD3
Writing the .hex file to the Seal requires the RMSA USB/Programmer. To write the .hex file to
a Seal, perform the following steps:
a Seal, perform the following steps:
• Select a Seal, remove the enclosure and connect the RMSA USB/Programming
dongle and ICD3 dongle shown in Section 2.1 of this User Guide.
• Start the MPLAB Integrated Development Environment (IDE) if it is not already
running. The program will confirm the existence of the ICD3 programming module
and ask the user to confirm the correct power supply setting. When the initialization is
complete, the prompt will indicate that the program is ready. If not, check dongle
cabling (as shown in Section 2.1) and repeat this step until the connection is indicated.
and ask the user to confirm the correct power supply setting. When the initialization is
complete, the prompt will indicate that the program is ready. If not, check dongle
cabling (as shown in Section 2.1) and repeat this step until the connection is indicated.
REMOTELY MONITORED SEAL ARRAY(RMSA)
SFG-MAN-001
REVISION: 1.7
2016 CANBERRA
20