BMT Holdings Pty Ltd A310V6 Manual De Usuario
BMM
®
System
Manual
– Blast Anytime BMM Activator
2
www.bmt.com.au
2
U
SING THE
BMM
A
CTIVATOR
2.1 Turn On the Activator
• Turn on the Activator by pressing and holding the
red
button
❶ for 2 seconds. The digital display
❹ will simply show “00”.
• Note: the Activator will vibrate in response to any
button press. It works as a feedback mechanism to
verify that the button was pressed.
• The Activator has two modes of operation; BAT
(Blast Anytime)
and Normal
mode.
• The mode is set in BMT’s factory or through BMM
Explorer’s Licence Manager.
• To save the battery, the Activator automatically
turns off after 10 minutes if no button is pressed.
2.2 Turn On a BMM
• Position the Activator close to the BMM to be switched on (within 100mm or 3in), and press
the green
BMM ON
button
❷ briefly – the green (transmit) LEDs ❺ will illuminate. Activation
is more reliable if the Activator is positioned above the BMM as shown in the photo.
• The BMM is turned on when the red (receive) LEDs ❻ illuminate and you hear an audible
tone
at regular intervals (beep, beep, beep, beep…).
• Keep the Activator within range of the BMM
for at
least ten seconds to make sure the red LEDs
remain on.
As a final check to make sure the BMM has been
turned on, move the Activator out of range of the
BMM and then back within range. The red LEDs
❻ should illuminate again.
❻ should illuminate again.
• If the Activator does not beep and the red LEDs do
not illuminate, move the Activator around the BMM at various angles and try again.
WARNING
A BMM cannot be switched off once activated
Hold the Activator to the BMM and press BMM On.