CEI Conrad Electronic International Limited RCE-NAVIGATOR Manual De Usuario

26  |  Calibration

 

D

You need to perform this step with precision or the Navigator 250 will not fly properly.

1.  Tap the calibration button (right button) two times (2x) quickly to enter Gyro Calibration.

2.  Place the Navigator 250 on a horizontal and level surface and wait for a single beep.

3.  Rotate the Navigator 250 by 180° about its vertical axis. Refer to »Fig. 10, steps A and B.

4.  2 beeps confirm the successful completion of the gyro calibration procedure.

5.  Tap the calibration button once (1x) to proceed to Compass calibration.

Fig. 10

 

D

You need to perform this step with precision or the Navigator 250 will not fly properly.

 

Perform  the  compass  calibration  in  an  open  area,  away  from  metal  objects,  high-

voltage powerlines, radio towers/masts and any portable or stationary devices sending

and receiving radio signals in order to eliminate magnetic interference.

 

Calibration failed: Calibration can fail in each step (3 beeps). In case of failure, move

away from magnetic interferences and restart the procedure.

1.  Tap the calibration button two times (2x) quickly to enter calibration.

2.  Rotate the Navigator 250 in sequence as shown in »Fig. 11, A to D. Wait for confirmation:

 

▬

Successful (2 beeps), Failed (3 beeps)

3.  Tap the calibration button once (1x) to conclude and exit the calibration mode.

Fig. 11