CEI Conrad Electronic International Limited RCE-NOVAX350 Manual De Usuario
Calibration | 33
5. Hold the »NovaX 350 horizontally and its nose pointing away from you.
6. Rotate the »NovaX 350 two times (2x) about its lateral axis by 360°as shown in step [1].
7. Rotate the »NovaX 350 clockwise about its vertical axis by 90°as shown in step [2].
6. Rotate the »NovaX 350 two times (2x) about its lateral axis by 360°as shown in step [1].
7. Rotate the »NovaX 350 clockwise about its vertical axis by 90°as shown in step [2].
Wait for a single beep.
8. Rotate the »NovaX 350 two times (2x) about its longitudinal axis by 360°as shown in
step [3].
9. Rotate the »NovaX 350 two times (2x) clockwise about its vertical axis by 360° as
shown in step [4].
10. Wait for confirmation: succeeded (2 beeps), failed (3 beeps).
11. Remove the canopy.
12. Complete the procedure.
11. Remove the canopy.
12. Complete the procedure.
27.8 ESC (Electronic speed controller)
ESC calibration is performed during production and does
only need to be performed again after replacing the ESC.
If you encounter problems with your ESC then our support
service may instruct you to re-calibrate the ESC. Do not
perform this calibration unless you are asked to do so.
only need to be performed again after replacing the ESC.
If you encounter problems with your ESC then our support
service may instruct you to re-calibrate the ESC. Do not
perform this calibration unless you are asked to do so.
Remove the propellers before you proceed.
ESC calibration cannot be started in calibration mode.
1. Connect the flight battery to the »NovaX 350.
2. Remove the canopy.
3. Press and hold the PCB button until the motor driver starts to beep.
4. After you have successfully calibrated the ESC, disconnect the battery.
5. Replace the canopy.
2. Remove the canopy.
3. Press and hold the PCB button until the motor driver starts to beep.
4. After you have successfully calibrated the ESC, disconnect the battery.
5. Replace the canopy.
1
2
180°
3
Fig. 12
1
2
3
4
Front
Rear
Fig. 13