CEI Conrad Electronic International Limited RCE-NOVAX350 Manual De Usuario

Descargar
Página de 52
38  |  Flight Modes
30.5.4.1  Fixing the ‘Home’ location
Once the motors have been started and the »NovaX 350 is receiving a good GPS signal
(solid blue LED) it registers and locks the motor start location as ‘home’.
If you started the motors in another than your preferred ‘home’ location, turn the motors off
and unplug and reconnect the flight battery, then register a new home location by turning
the motors on again.
(White)
(White)
Fig. R.T.H.
Beep beep ... pause ...
Beep
Beep
Beep
Fig. 17
Agility
For all three flight modes – Basic, Altitude and GPS – you can set two AGILITY LEVELS, 
and even mix your own according to your preferences. The agility level is set through
channel 6 (Ch 6) on your transmitter. Study the following table:
Agility
Switch position
Description
AP
Pos. 1
Aerial photography mode
Low agility. Preset for smooth aerial application.
Sport
Pos. 2
Sport mode
Strong agility. Fast sport and fun flights.
Does not permit flips.
Custom*
Pos. 3
Custom agility levels and I.R.P.C. settings;
Set in EYECONTROL app;
Replaces either AP or Sport agility;
* The user can set the agility according to their preferences, either with lower or higher
agility. In the initial release version the custom agility levels lie between the endpoints of
the AP and Sport agility levels. In future firmware releases the range may be increased for
increased agility or even flipping. The custom agility level can be dragged and dropped
within the EYECONTROL app onto either position 1 or 2 of the channel 6 (Ch 6) switch, 
replacing AP or Sport agility respectively.
30.6  I.R.P.C.
I.R.P.C (Intelligent Relative Positioning Control) controls the »NovaX 350 relative to the
take-off position. For a quick introduction to I.R.P.C., we suggest you watch the following
short clip(s): 
Video: 
https://vimeo.com/128193344
30.6.1  Programming and activating I.R.P.C.
I.R.P.C. is activated by switching the bank selection switch to position 3 (custom mode),
but must be set in the EYECONTROL app. Follow the instructions given in the app.