GE Inspection Technologies LP 7260H Manual De Usuario

 – Tap the lower-left corner of the display (typically contains a GE Logo) or (or press 

the 

 hard key) at any time to open the Global Menu, which provides access to 

the Setup Menu.  

 – Select to alter the Measurement and Annotation-specific settings shown here.  

 – View the list of 3DPM Tips already calibrated for use with the attached probe. 

 – Select to view a list of Stereo Tips already-calibrated for use with the attached 

probe. The Add Tip and Edit List options are not intended for general use. Deleting 

a tip through the Edit List option will permanently remove that tip’s calibration data 

requiring the probe and tip to be returned to an authorized GE Inspection Technologies 

service center for re-calibration.

 – Save Preset Annotation (notes) to an external storage device or Import preset notes 

to the instrument from an external device.

 – Displays or removes the Zoom Window (used for detailed cursor placement during 

measurement). 

 – Select AUTO to show the 3DPM red/yellow un-measurable pixel mask only when a 

cursor is placed on a red/yellow pixel. Select ON to always show the pixel mask when 

measuring.  

 – Select Z-Map for most usage. P-Map images contain additional data and may be 

requested by GE Technical Support to aid in troubleshooting.

 – Controls the display of the Stereo Index, which appears during Stereo Measurement. 

 – Sets a threshold value for the Stereo Index below which the index flashes during 

Stereo Measurement.  This may be used to warn the user of low-index measurements 

where the accuracy may be reduced.

 – Specify the unit of measurement as Inches or Millimeters.