SES-imagotag GmbH E00023 Manual De Usuario
Quick Start Guide
Page 22 of 50
Note: After the basic configuration in the AP-2010 web UI, it is also possible to fill in AP-ID and
AP-IP-Address automatically. For this choose "Create Configuration..." under System – Access
Point Status - Right click on the discovered and configured Access Point.
AP-IP-Address automatically. For this choose "Create Configuration..." under System – Access
Point Status - Right click on the discovered and configured Access Point.
After saving the AP configuration you should see the AP under System – Access Point Status
as ONLINE. In addition the AP status LED should turn
as ONLINE. In addition the AP status LED should turn
BLUE
.
Note: It is possible to configure the access point via hostname. To get this working there has
to be a corresponding entry in the DNS.
to be a corresponding entry in the DNS.
5.1.5 The Status LED
There are several LED colors that indicates the main status of the access point.
Color
Description
Note
Red
Boot process
Can take about 2 minutes, if it takes much
longer, the device is defective and there is a
need for service.
longer, the device is defective and there is a
need for service.
Blue
Normal mode
---
Yellow
Operational, but not
connected to any server
or no channel selected
connected to any server
or no channel selected
---
Red (blinking) Running Firmware Update
During this time there is no connection to the
electronic label
electronic label
If there are any problems regarding the access point please see chapter [Troubleshooting].
5.2 Connect and configure MAP-2014 T/Q & LANCOM L-151e/322e
The LANCOM Access Point with Wireless-ePaper is the communication center in the store that
transmits price information to the labels. In order to ensure the communication between ESL
server, access point and the labels the LANCOM Access Point with Wireless-ePaper has to be
connected after the start of the ESL Server.
transmits price information to the labels. In order to ensure the communication between ESL
server, access point and the labels the LANCOM Access Point with Wireless-ePaper has to be
connected after the start of the ESL Server.
One way to configure the access point is on the client.
5.2.1 First configuration steps
As described in the Installation Guide (printed version included in the package) you’ll have to
configure the basic settings before setting up Wireless-ePaper using the imagotag imagotag
Core Service.
configure the basic settings before setting up Wireless-ePaper using the imagotag imagotag
Core Service.
1. Installing the software or configuration using a web browser and setup wizards
2. Deploying and connecting the device
3. Searching for and configuring the device
2. Deploying and connecting the device
3. Searching for and configuring the device
After setting up the basic settings the following points have to be fulfilled: